AT&T HS-8211 user manual Replacing the Handset Battery Pack

BATTERIES

Nickel-Cadmium Rechargeable Batteries must be recycled or disposed of properly. Do not dispose of in household garbage. If burned, it could explode. If punctured, it could release caustic material which could injure the skin or eyes. If swallowed, it may be toxic.

The RBRC™ seal means that the manufacturer is voluntarily participating in an industry program to collect and recycle Nickel-Cadmium rechargeable batteries when taken out of service within the United States. These batteries may be taken to a participating local retailer of replacement batteries or recycling center. Or, you may call 1–800–8BATTERY for locations accepting spent Nickel-Cadmium batteries.

Replacing the Handset Battery Pack

1Remove the battery compartment cover on the handset by pressing on the indentation and sliding the cover downward.

2Lift out the old battery pack and disconnect.

3Align the two holes in the new battery pack’s plug with the socket pins, and snap the plug into place. Place the battery pack in the compartment with the wires in the lower left corner, along the bottom of the battery pack.

4Replace the cover by sliding it up into place.

5The new battery pack must be charged before using the phone. Place the handset in the base and allow it to charge for at least

24 hours the first charge. The telephone might operate before that, but for best performance, let the battery pack charge fully.

RBRC is a registered trademark of the Rechargeable Battery Recycling Corporation.

14