![INSTALLATION CAUTIONS & WARNINGS](/images/new-backgrounds/42740/427403x1.webp)
INSTALLATION CAUTIONS & WARNINGS
1.BEFORE BEGINNING, check all vehicle manufacturer cautions and warnings regarding electrical service (AIR
BAGS, ABS BRAKES, AND BATTERY).
2.TO PREVENT A POSSIBLE DEAD BATTERY remove vehicle dome light fuse while working on the vehicle.
MAKE CERTAIN TO REINSTALL FUSE PRIOR TO TESTING FOR DOOR TRIGGERS.
3.DO NOT EXCEED MAXIMUM OUTPUT RATINGS - SERIOUS DAMAGE MAY OCCUR. Limits for alarm and remote start functions are listed in the main diagram and wiring descriptions page. If you are unsure about current load, measure the load with an
4.REMOVE MAIN SYSTEM FUSE(S) before jump starting the vehicle. DAMAGE MAY OCCUR TO SYSTEM IF PROPER PRECAUTIONS ARE NOT OBSERVED.
5.DO NOT INSTALL CS9704RS ALARM/AUTOSTARTER in vehicles with MANUAL TRANSMISSIONS. Accidentally left in gear, a remote started vehicle could become a
6.DO NOT EXTEND
7.DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED with brake, and gas pedals, steering column, or any other moving parts in the vehicle.
8.WHEN STARTING THE VEHICLE IN A GARAGE, make sure that door is open or adequate ventilation is provided.
SUGGESTED COMPONENT MOUNTING
Control Module: Driver’s side underdash, the unit should be placed as high as possible, not easily accessible.
Shock Sensor: Mount with wire ties to an under dash wire harness or fasten with screws to a panel.
Siren: under the hood to
Override/Program button: hidden location, but accessible to the user in case the system must be disarmed without the use of the transmitter. This switch is also used to program certain features.
Antenna Assembly: inside front left windshield (close to window frame) using supplied double sided tape.
2