WIRING
2 PIN PLUG (WHITE) |
Connect to terminal 85 of relay. This wire turns the dome light on for 30 seconds upon disarming of the alarm. If the ignition is turned on or the alarm is
This wire provides a pulsed 150mA negative output for honking the vehicle's horn when the alarm is triggered. Connect this wire to the horn relay in the steering column. If there is no horn relay you must install one.
NOTE: Some vehicle horns operate only with ignition on. This will require rewiring the horn circuit in order for the alarm system to operate the horns. Call technical support for details.
| 2 PIN PLUG (BLUE) |
| 2 PIN PLUG (RED) | |||||
PROGRAM/OVERRIDE BUTTON |
|
| LED INDICATOR (Red flashing light) |
| ||||
| 3 PIN PLUG (RED) |
|
|
|
|
| ||
GRN/BLK PIN 1: | NEGATIVE REMOTE OUTPUT (Optional) |
|
|
| ||||
RED | PIN 2: | FACTORY DISARM (Negative pulse) |
|
|
| |||
YELLOW | PIN 3: | VACUUM INPUT (Used when installing a vacuum switch for engine monitor) | ||||||
| 3 PIN PLUG (WHITE) |
|
|
|
|
| ||
GREEN | PIN 1: | NEGATIVE LOCK | Connect directly to negative lock/unlock systems. If vehicle | uses | ||||
RED | PIN 2: | +12V For Relays | positive door lock signals or reversing polarity type, then external | |||||
BLUE | PIN 3: | NEGATIVE UNLOCK | relays must be added. Door lock wires are usually found in | |||||
| 4 PIN SENSOR PLUG (22 GAUGE WIRES) |
|
|
| ||||
WHITE | PIN 1: | NEG. | The Dual Stage Pre- | Warn Shock sensor connects directly to | ||||
BLACK | PIN 2: | SENSOR GROUND | Alarm Brain with | |||||
BLUE | PIN 3: | NEG. TRIGGER | sensors, you must | |||||
RED | PIN 4: | SENSOR +12V | wire. Place a diode | |||||
|
|
|
| sensor. |
|
|
|
OPERATION
5