Zebra Technologies ZD500 manual Print Mode, Label Top, Label Left, Reprint

54

Printer Configuration

Changing Printer Settings

Table 7 • SETTINGS Menu (Continued)

Print Mode	Select a print mode that is compatible with your printer options.
	Accepted values:	•	TEAR OFF
		• PEEL OFF (use this value for Label Dispensing:
			Separates the liner from the label and presents a
			peeled label to the operator)
		•	REWIND
		•	CUTTER
		•	DELAYED CUT
		•	LINERLESS PEEL
		•	LINERLESS REWIND
		•	LINERLESS TEAR
	Related ZPL command(s):	^MM
	SGD command used:	media.printmode
	Printer web page:	View and Modify Printer Settings > General Setup >
		Print Mode
Label Top	If necessary, shift the print position vertically on the label. A negative value moves the
	format towards the top of the label; a positive value moves the format away from the top of
	the label.
	Accepted values:	–120 to 120
	Related ZPL command(s):	^LT
	SGD command used:	zpl.label_top
	Printer web page:	View and Modify Printer Settings > Advanced Setup
		> Top Position
Label Left	If necessary, shift the print position horizontally on the label. Positive numbers move the left
Position	edge of the image toward the center of the label by the number of dots selected, while
	negative numbers move the left edge of the image toward the left edge of the label.
	Accepted values:	–9999 to 9999
	Related ZPL command(s):	^LS
	SGD command used:	zpl.left_position
	Printer web page:	View and Modify Printer Settings > Advanced Setup
		> Left Position
Reprint	When reprint mode is enabled, you can reprint the last label printed by pressing and holding
Mode	PAUSE + CANCEL on the printer’s control panel.
	Accepted values:	•	ON
		•	OFF
	Related ZPL command(s):	^JZ
	SGD command used:	ezpl.reprint_mode
	Printer web page:	N/A

P1062653-002 Rev. A ZD500 Series™ Thermal Transfer Printer User’s Guide 1/16/2014