Zebra Technologies ZD500 Compliance and Regulatory Statements

1/16/2014 ZD500 Series™ TThermal Transfer Printer User’s Guide P1062653-002Rev. A

Compliance and Regulatory Statements

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for Class B Digital

Devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a residential

environment. This equipment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the product manuals, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception, the user is encouraged to do one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced RF service technician for help.

Important •

1. The radio must be installed with a minimum 20 cm separation between the user and the

antenna.

2. The radio must not be co-located or used in simultaneous transmitting condition with

another radio.

3. The host system shall have a label to indicate that the system contains a certified module.

An example is “Contains FCC ID : I28MD-EXLAN11N , IC ID: 3798B-EXLAN11N��.

4. The radio is for indoor use only in the 5150-5250 GHz frequency range.

The user is cautioned that any changes or modifications not expressly approved by Zebra

Technologies could void the user’s authority to operate the equipment. To ensure compliance,

this printer must be used with fully shielded communication cables.

Este equipo ha sido diseñado para operar con las antenas que enseguida se enlistan y para una

ganancia máxima de antena de [x] dB. El uso con este equipo de antenas no incluidas en esta

lista o que tengan una ganancia mayor que [x] dB quedan prohibidas. La impedancia requerida

de la antena es de [y] ohms.

• Gain = 2.77dbi @ 2.4 GHz

• Gain = 2.69 - 3.19dBi @ 5 GHz

• Impedance = 50 ohms