Zebra Technologies ZD500 - page 71

59
Printer Configuration
Changing Printer Settings
1/16/2014 ZD500 Series™ Thermal Transfer Printer User’s Guide P1062653-002 Rev. A
Load Defaults Load Printer or Print Server Defaults
•FACTORY—Restores all printer settings other than the network settings back to the
factory defaults. Use care when loading defaults because you will need to reload all
settings that you changed manually.
•NETWORK—Reinitializes the printer’s wired or wireless print server. With a
wireless print server, the printer will also reassociate with your wireless network.
•LAST SAVED—Loads settings from the last permanent save.
Accepted values: •FACTO RY
•NETWORK
•LAST SAVED
Related ZPL command(s): Factory: ^JUF
Network: ^JUN
Last saved: ^JUR
SGD command used: none
Control panel key(s): Factory: Hold FEED + PAUSE during printer
power-up to reset the printer parameters to factory
values.
Network: Hold CANCEL + PAUSE during printer
power-up to reset the network parameters to factory
values.
Last saved: N/A
Printer web page: Factory: View and Modify Printer Settings >
Restore Default Configuration
Network: Print Server Settings > Reset Print
Server
Last saved: View and Modify Printer Settings >
Restore Saved Configuration
Manual
Calibration
Calibrate the printer to adjust the sensitivity of the media and ribbon sensors.
For complete instructions on how to perform a calibration procedure, see Manual
Calibration - Media on page 75.
Accepted values: N/A
Related ZPL command(s): ~JC
SGD command used: ezpl.manual_calibration
Control panel key(s): Hold PAUSE + FEED + CANCEL for 2 seconds to
initiate calibration.
Printer web page: The calibration procedure cannot be initiated through
the web pages. See the following web page for
settings that are set during sensor calibration:
View and Modify Printer Settings > Calibration
Important • Do not change these settings
unless you are told to do so by Zebra
Technical Support or by an authorized service
technician.
Table 8 • TOOLS MENU (Continued)