41
Setup
Configure Using the Connectivity Wizard
1/16/2014 ZD500 Series™ Thermal Transfer Printer User’s Guide P1062653-002 Rev. A
15. Determine if you will send the script immediately, or save it for use at a later time.
16. Observe the wireless status on the printer’s control panel, and confirm that you have set up
your printer for wireless connectivity. Printers that have an LCD display text or symbols
(see Table 5 and Table 6).
To... Then...
Complete setup by sending
the ZPL script to the printer
through the port selected at
the beginning of this
procedure
a. Verify that the printer is connected to the computer
through the port you selected.
Note • For serial connections, use a serial null
modem cable.
b. If you have not already done so, turn on (I) the printer.
c. On the Review and Send ZPL for Wireless window,
click Finish.
The printer sends the ZPL script to the printer through
the selected port. The Wireless Setup Wizard screen
closes.
d. Turn the printer off (O) and then back on (I).
Save the ZPL script to a file
for later use or for use on
other printers
Note • You can send the ZPL script file to
multiple printers that use the same configuration,
or you can send the file to a printer that had the
network settings restored to the factory defaults.
This saves you from having to go through the
Wireless Setup Wizard more than once.
a. On the Review and Send ZPL for Wireless window,
highlight the script, right-click, and select Copy.
b. Open a text editor, such as Notepad, and paste the
script into the application.
c. Save the script.
d. In the Connectivity Wizard, click Cancel to exit
without sending the script at this time.
e. If you have not already done so, turn on (I) the printer.
f. Send the ZPL file to the printer through the connection
of your choice.