To eliminate siren chirps, turn the ignition on and press the transmitter’s remote start button for about 3 seconds. You will hear a short double chirp. After the ignition is turned off, there will be no siren chirps for arm, disarm and remote start engage/reset confirmation. To revert back to siren chirps, perform the same procedure (there will be 2 short double chirps when
ACTIVE RE-ARM PROGRAMMING:
To disable this feature, turn the ignition on and press the transmitter’s lock button for about 3 seconds. 2 siren chirps will sound confirming the feature has been disabled. To
REMOTE START PROGRAMMING OPTIONS
The
Dip Switch Number | Settings |
|
|
#1 Tach/Tachless or Vacuum | ON = Tach/Tachless | OFF = Vacuum | |
#2 Crank Time (.8 or1.25 Sec.) | ON = .8 Sec. | OFF = 1.25 Sec. | |
#3 Gas / Diesel | ON = Gas | OFF = Diesel | |
#4 Engine or Tachless Monitor | ON = Tachless | OFF = Engine Monitor |
TACH/TACHLESS MODE:
In Tach/Tachless Mode, the selection of dip switch #4 determines if the system will be monitoring the gray Engine monitor wire or if no wire will be used (Tachless Mode).
VACUUM MODE:
In Vacuum Mode (switch #1 off), connect the Yellow Vacuum Monitor wire to a vacuum switch (not included) which connects to an engine vacuum hose. When there is no vacuum (engine not running), a ground will be present and the starter will crank. When vacuum is present (engine running), the switch will activate removing the ground.
REMOTE START PROGRAMMING OPTIONS
CRANK TIME:
9