AT&T Partner Plus manual Wall Mounting Phones with Separate Stands

Wall Mounting

If you wall mount a display phone, the display may be difficult to read, so desk mounting is recommended. (Wall mounting instructions apply to corded MLS-model phones only. To wall mount an MLC-6 cordless phone, follow the instructions in the booklet provided with the phone.)

Wall Mounting Phones with Separate Stands

1

2

3

Reverse the plastic hook that sits in the earpiece part of the handset cradle.

A)To install the telephone stand, gently place the phone upside down with the low end of the phone to your right.

B)Insert the tab on the narrow end of the stand into the left slot on the base of the phone. (For an MLS-34D phone, feed the cord through the hole in the center of the stand and plug it in.)

C)Insert the other tab into the right slot, pushing the stand down and slightly inward until the tab locks into place.

A)Insert the phone cord through the center of the stand and plug it into the jack on the base of the phone, then plug the other end into the modular wall jack.

B)Mount the phone on the wall plate using the screw keyholes on the base of the stand. For proper mounting, the wall plate must be an AT&T 630B connecting block.

C)Connect the handset cord as described in “Desk Mounting,” Step 1A, and label the button

sheet as in Steps 3A and 3B.

Wall Mounting Phones with Fixed Stands

Make sure the telephone cord is unplugged from the bottom of the phone before proceeding.

1 A) Reverse the plastic hook that sits in the earpiece part of the handset cradle.

B) Gently place the phone upside down.

Installation Procedures 13