Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status (see table below). If necessary, place the handset in the charger to charge the battery. For best performance, keep the handset in the charger when not in use. The battery is fully charged after 16 hours of continuous charging. See the table on page 33 for battery operating times.
If the screen shows Low battery, you need to charge the battery without interruption for at least 25 minutes to give the handset enough charge to use the telephone for a short time. The following table summarizes the battery charge indicators and actions to take.
Battery indicators | Battery status | Action | ||
|
|
|
|
|
The screen is blank or | The battery has very little | Charge without | ||
shows Place in charger. | or no charge. The handset | interruption until the | ||
|
|
| cannot be used. | screen shows |
|
|
|
| Low battery or |
|
|
|
| HANDSET X (at least |
|
|
|
| five minutes). |
|
|
|
|
|
The screen shows | Battery has enough | Charge without | ||
Low battery and |
|
| charge to be used for a | interruption until |
| ||||
flashes. | short time. | the screen shows | ||
|
|
|
| HANDSET X (at least |
|
|
|
| 25 minutes). |
|
|
|
|
|
The screen shows | Battery is charged. | To keep the battery | ||
HANDSET X. |
| charged, place it in | ||
|
|
|
| the charger when not |
|
|
|
| in use. |
|
|
|
|
|
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every minute.
