Getting started
Battery installation & charging
Install the battery as shown on the next page. Once you have installed the battery, the screen indicates the battery status (see table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the charger when not in use. The battery is fully charged after 16 hours of continuous charging. See the table on page 37 for battery operating times.
If the screen is blank, you need to charge the handset without interruption for at least 10 minutes to give the handset enough charge to use the telephone for a short time. The screen shows LOW BATTERY and the backlight is off until you have charged the battery without interruption for at least one hour. The following table summarizes the battery charge indicators and actions to take.
Battery indicators | Battery status | Action | |
The screen is | Battery has no | Charge without | |
blank. | charge and the | interruption until the | |
| handset cannot be | screen shows LOW | |
| BATTERY (at least 10 | ||
| used. | ||
| minutes). | ||
|
| ||
The screen | Battery has very | Charge without | |
shows PLACE IN | little charge and | interruption until the | |
CHARGER and | the handset cannot | screen shows LOW | |
flashes. | be used. | BATTERY (at least | |
four minutes). | |||
|
| ||
The screen shows | Battery has enough | Charge without | |
LOW BATTERY and | charge to be used | interruption until | |
flashes. | for a short time. | the screen shows | |
HANDSET X (at least | |||
|
| ||
|
| one hour). | |
The screen shows | Battery is charged. | To keep the battery | |
HANDSET X. |
| charged, place it in | |
|
| the telephone base | |
|
| or charger when not | |
|
| in use. |
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every minute.