Chapter 2. Hardware Setup

Single Stage Installation

In a single stage installation, there are no additional switches daisy-chained down from the first unit. To set up a single stage installation do the following:

1.Plug your keyboard, mouse, and monitor into the unit's console ports.

2.Use KVM cable sets (as described in the Cables section on page 4), to connect any available KVM port to the keyboard, video and mouse ports of the computer you are installing.

Note: Ignore the daisy-chain ports at this time. They are only used when daisy-chaining additional Master View units. Daisy-chaining is described in the next section.

3.Plug the power adapter cable into the Master View's power jack, then plug the power adapter into an AC power source.

4.Turn on the power to the computers.

Single Stage Installation Diagram

9