ATEN Technology AS-411S, AS-811P, AS-811S, AS-411P user manual Manual Switching Mode

POWER ON PROCEDURE AS/2 Auto Switch

3)When the ‘READY’ LED turns off, it indicates Connectors are not properly connected, Printer(or output device) is not switched on, Printer is not in ON-LINE status,

or, Printer is out of paper.

If buffer card installed for output ‘READY’ LED reflects buffer readiness.

4)When the AS/2 is serving a certain input channel, it does not switch to serve another channel even though the printing gets interrupted by printer’s power off or printer out of paper, etc.

NOTE: Only in the Manual Switching Mode user can force the AS/2 to switch to and service another input channel.

3-3 MANUAL SWITCHING MODE

1)	Press the ‘SELECT’ button on the left side of the front panel to see the
	corresponding LED comes on and the selected input channel’s LED
	remains lit.
2)	Now, the AS/2 is in the Manual Switching Mode. If the manual
	selected input channel stays on LED 1, then pressing the ‘SELECT’
	button again the AS/2 will switch the input channel to the next channel

LED 2. Pressing the ‘SELECT’ button again, it will switch to the next channel LED 3, and so on.

3)If the manual selected input channel stays on LED 4 (or LED 8), then pressing the ‘SELECT’ button the AS/2 will enter Auto Switching Mode and LED 1 - LED 4 (or LED 8) turned on.

16 User’s Manual