ATEN Technology AS-411P, AS-811P, AS-811S Power On Procedure, Auto Switching Mode, User’s Manual

AS/2 Auto Switch POWER ON PROCEDURE

3 POWER ON PROCEDURE

3-1 POWER ON PROCEDURE

1)To reset the AS-81 1 P and AS-41 1 P (w/ buffer card), turn off/on power switch. AS-41 1 P (w/o buffer card) can be reset by recycling printer power while it is hooked to a printer.

2)After reset, the input channel’s service LEDs are on. Meanwhile, the AS/2 is ready for operation and it enters the auto switching mode automatically.

3-2 AUTO SWITCHING MODE

1)In auto switching mode, all see the input channel’s service LEDs are on. That means the AS/2 is standing by to get data from all channels.

2)If any input channel requests to be served, the requested channel LED will be on and the AS/2 will lock on to that channel. At this moment the output port of AS/2 will’ only serve the locked input channel until all the input data from the requested channel has been sent out and also the time out period is up. The time out setting depends on the current DIP Switch’s Setting of AS/2.

User’s Manual 15