Chapter 1. Introduction
LCD Module
1
|
| 2 |
|
|
| 3 |
|
|
| 4 | 5 |
No. | Component |
| Description |
1 | LCD Display | To access the LCD monitor, slide the LCD module out and flip | |
|
| up the cover. See Opening the Console, page 15, for details | |
|
| on sliding the LCD module out. | |
2 | LCD Controls | These buttons control the position and picture settings of the | |
|
| LCD display. See LCD OSD Configuration, page 22, for | |
|
| details. |
|
3 | LCD On/Off | Push this button to turn the LCD monitor on and off. The | |
| Button | button lights when the LCD monitor is off to indicate that only | |
|
| the monitor is off – not the KVM switch itself.) | |
4 | Firmware | The Firmware Upgrade Cable that transfers the firmware | |
| Upgrade Port | upgrade data from the administrator's computer to the KL1100 | |
|
| plugs into this | |
5Firmware Upgrade Switch
During normal operation and while performing a firmware upgrade, this switch should be in the NORMAL position. If a firmware upgrade operation does not complete successfully, this switch is used to perform a firmware upgrade recovery. See Firmware Upgrade Recovery, page 31, for details.
7