Chapter 2. Hardware Setup

SN0108 / SN0116 PC Installation

Refer to the Installation Diagram on page 12 (the numbers in the diagram correspond to the numbers of the steps), as you do the following:

1.For each server or serial device, plug an RJ45 to Serial adapter into its serial port. (See RJ-45 to Serial Adapters, page 92, for details on choosing the appropriate adapter.)

Note: RJ-45 to Serial adapters require a separate purchase. To purchase RJ-45 to Serial adapters, contact your dealer.

2.Use standard Ethernet cable to connect any available port on the SN0108 / SN0116's rear panel to the adapter.

3.If you choose to install a serial modem for OOB operation (see Chapter 6), use standard Ethernet cable to connect any available port on the SN0108 / SN0116's rear panel to a DTE to DCE serial adapter (see RJ-45 to Serial Adapters, page 92 for details on choosing the appropriate adapter), then plug the adapter into the modem's serial port.

Note: This step is optional.

4.Plug the cable that connects the SN0108 / SN0116 to the network or the Internet into its LAN port.

5.Use the AC power cord provided with this package to connect the SN0108 / SN0116's Power Socket to an AC power source.

This completes the SN0108 / SN0116 installation.

11