Installation

1.Make sure that the power to all devices you will be installing has been turned off.

2.Make sure that all devices you will be installing are properly grounded.

Installation of the VS0801 is simply a matter of plugging in the appropriate cables.

To install the switch, refer to the installation diagram on page 12 as you perform the following three steps:

1.Use a VGA cable to connect the VGA input port on the video display device to the VGA output ports on the rear of the VS0801. Connect your speakers to the Audio output port.

2.Use VGA/Audio cables to connect the VGA/Audio output ports on the source device(s) to the VGA/Audio input ports on the VS0801. Eight VGA/Audio input ports are located on the rear of the switch.

3.Plug the provided power adapter into an appropriate AC power source; plug the power adapter cable into the Power Jack on the VS0801.

This completes the basic installation of the VS0801 8-port Video Switch. You may now power on the display and source devices.

Installing the RS-232 Controller

In order to use the RS-232 serial interface to attach a high-end controller (such as a PC) to the VS0801, use a serial cable such as a modem cable. The end connecting to the VS0801 should have a 9-pin male connector. Connect this to the serial interface on the rear of the VS0801. Refer to number 4 on the diagram on page 12.

Note: To configure the controller serial port, see page 14.

- 11 -