Atlantic Technology 102 SB, 422 SB, 212 SB instruction manual SB Subwoofer Rear Panel, Phase Switch

Subwoofer Rear Panel 3

Instruction Manual

102 and 212 SB Subwoofer Rear Panel

Figure 1

1

2

3

4

5

6

7

8

BASS LEVEL
	MIN	MAX
		STATUS
STANDBY	ON	AUTO
		60 Hz
CROSSOVER
FREQUENCY
	40 Hz	140 Hz
PHASE	NORMAL	INVERT
CROSSOVER	NORMAL	BYPASS
	RIGHT	L / MONO
OUTPUT
INPUT

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK

DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR

DOUBLE INSULATION - WHEN SERVICING USE ONLY IDENTICAL REPLACEMENT PARTS

2001310

�����������

�����������

������������

������������������

AC

INPUT

ON

9

10

11

12

CAUTION: FOR CONTINUED PROTECTION AGAINST	FOR 115V, USE T2AL 250V FUSE
FIRE, REPLACE ONLY WITH SAME TYPE 250V FUSE	FOR 230V, USE T1.25AL 250V FUSE

1Variable Level Control

Use this control to set the level of bass desired

2Status LED

This will be green for "on" condition, amber for "standby"

3Standby Switch

When in ON position,the amplifier will always be on.When in the AUTO position, the amplifier will be in Automatic Standby Mode. (pages 5 and 9)

4Crossover Control

An adjustable (40Hz to 140Hz) @ 18dB per octave low-pass cross- over. (pages 5 and 9)

5Phase Switch

This switch allows precise acoustic matching with satellite speaker systems whose output may be phase reversed. (pages 5 and 10)

6Crossover Switch

When in the NORMAL position, adjustment of the crossover can be made by the Crossover Control.If being fed a pre-filtered or THX signal, place the switch at the BYPASS position. (pages 5 and 9)

7Low Level Output

The outputs allow daisy chaining of multiple subwoofers, or as a return path back to the processor. (pages 5 and 6)

8Low Level Input

Use the input to connect to the subwoofer or LFE line out from your processor/receiver. (pages 5 and 6)

9Product Serial Number

Write this number in the space provided on page 2 for future reference.

10Voltage Select Switch

Voltage switch for use in different countries.This switch will be set when you receive the unit. Change this setting only when you are sure your application requires it. For US, the switch should be set to the 110-120V position.

11On/Off Switch

Use this switch to turn the amplifier completely on or off.

12AC Input

Use the included power cord to connect your amplifier to a wall outlet. (pages 5 and 6)