ATLAS SOUND PA702,
1
| FUSE |
|
|
|
|
|
|
2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 |
Rear Panel
1.IEC AC Receptacle
Connect this grounded power cord to 120VAC circuits only. Serious damage may result otherwise.
2.AC Mains Fuse
For 100v – 120v operation use Slow Blow T3.15A 250v, 5mm x 20mm.
3.UNSWITCHED OUTLET
The
4.RCA Input
Unbalanced signals are accepted when using the Left and Right RCA connectors.
5.Balanced Input Connections
Left and Right balanced input signals can be accomplished by wiring the removable Phoenix type connector per the labeling on the rear of the amp. Note: The middle pin is the common ground connection for both Left and Right input ground. For unbalanced signals connect the
6.Speaker Connections
A removable Phoenix type connector is supplied to connect your speakers to the PA702. It is recommended to use 16guage wire or higher for connection to the speaker. Note: Do not overload the amp by connecting to many speakers to the amp. Four ohms per channel is the maximum load.
7.Four Position Dip Switch Assignment
Switch 1 - Sense On / Off, this switch activates the PA702 remote turn on sensing circuits via either Audio or AC trigger. When the switch is in the “UP” position, all trigger circuits are bypassed. The only way to turn the amp On or Off is via the mains AC Power Switch located on the front panel. When in the “DOWN” position either the Audio or AC Sense turn on Triggers is activated. See switch 2 for selection.
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • | TELEPHONE: (800) | FAX: (800) | |
©2007 ATLAS SOUND LP | Printed in China | ATS002604 RevA 03/07 | PP |
7