Captive Screw

Captive screw connectors are an added feature on the HD Extenders. The captive screw connectors allow you to cut cables to a suitable length, reducing cable clutter while providing a more reliable connection.

Connecting

When connecting the cables to the captive screw connector it is important that the wires be terminated correctly. The captive screw connector (see picture A) has a contact plate at the top and must have the wires touching it for signal to pass. When wired correctly (see picture B) the signal will pass, incorrectly (see picture C) no signal will pass.

The captive screw connectors have a contact bar that is adjusted to compress the wire against the top contact plate. Use the screws at the top of the connector to compress the wire against the contact plate.

Clockwise

Turn the screws clockwise to raise the contact bar to the upper contact plate and hold the wires in place.

Counter

Clockwise

Turn the screws counter clockwise to lower the contact bar to release the wires.

A

B

C

The power pin out (see picture 1) and wire configuration (see picture 2 and 3) are shown below.

1

- +

Black: - White: +

2

3

Note: When using the HDVS-RX do not connect a power supply to the HDVS-TX

atlona.com

5

Toll free: 1-877-536-3976

Local: 1-408-962-0515

 

 

Page 5
Image 5
Atlona AT-HDVS-TX user manual Captive Screw, Connecting