Atmel AT91SAM7L-STK Section 2

AT91SAM7L-STK Rev. A Starter Kit User Guide 2-1

6409A–ATARM–30-Jun-08

Section 2

Setting Up the AT91SAM7L-STK Rev. A Board

2.1 Electrostatic Warning

The AT91SAM7L-STK rev.A starter board is shipped in a protective anti-static package. The board must

not be subjected to high electrostatic potentials. A grounding strap or similar protective device should be

worn when handling the board. Avoid touching the component pins or any other metallic element.

2.2 Requirements

In order to set up the AT91SAM7L-STK rev.A starter board, the following items are needed:

The AT91SAM7L-STK rev.A starter board

Two AAA batteries

Contents

Main Page Page Page Section 1 Overview 1.1 Scope 1.2 Deliverables 1.3 The AT91SAM7L-STK Rev. A Starter Board Section 2 Setting Up the AT91SAM7L-STK Rev. A Board Page Setting Up the AT91SAM7L-STK Rev. A Board AT91SAM7L-STK Rev. A Starter Kit User Guide 2-3 6409AATARM30-Jun-08 2.6 AT91SAM7L-STK Rev. A Block Diagram SHEET3 Figure 2-2. AT91SAM7L-STK Block Diagram SHEET2 SHEET4 Section 3 Board Description 3.1 AT91SAM7L64/128 Microcontroller Page AT91SAM7L-STK Rev. A Starter Kit User Guide 3-3 6409AATARM30-Jun-08 3.2 AT91SAM7L64/128 Block Diagram SAM-BA APB Figure 3-1. AT91SAM7L64/128 Block Diagram SRAM Page 3.11 PIO Usage Table 3-1. PIO Controller A Table 3-2. PIO Controller B Table 3-3. PIO Controller C Section 4 Configuration 4.1 Configuration Straps Table 4-1. Page SHEET 2 SHEET 4 ERASE PA[0..25] PA[0..25] AD[0..3] ERASE AD[0..3] ZIGBEE INTERFACE Note: Pin 1 on Zigbee board RZ502 matches pin 2 on this connector SERIAL DEBUG PORT Only for AT86RF230Rev.A connexion not required for Rev.B on VCC/VBAT MONITOR FORCE WAKE-UP AT91SAM7L-LQFP128 FWKUP AT91SAM7L-LQFP128 RESET NRSTB ICE INTERFACE SAM7L Current measurement Section 6 Errata 6.1 Q1 Footprint Incorrect 6.2 MAX3318 Control Pull-ups Page Headquarters International Product Contact