If the devices connected to the Celerity FC host adapter are not accessible
1
2Select Properties.
3Select the Hardware tab.
4Select Device Manager.
•If the Celerity FC host adapter does not appear under the SCSI and RAID controllers, remove power from the PC, open the case, and check that the Celerity FC adapter is properly seated in the PCI slot. Replace the case and apply power.
•If the adapter has been identified but there is an exclamation point (!) on the listing, right click on the listing and select Uninstall.
5Reload the driver (see Installing and updating drivers on page 11).
6Reboot the system and repeat the installation process.
7If problems persist, contact your authorized ATTO Technology representative.
Linux
1Verify the celerityfc driver is loaded with the lsmod command. If lsmod does not show the driver, refer to the installation instructions to install and load the driver in Installing and updating drivers on page 11.
2Check the system log with the command dmesg. The celerityfc driver creates status messages during initialization. Make sure that all installed cards are properly detected and initialized.
3Examine the contents of the file(s) /proc/scsi/celerityfc/X, where X is the adapter’s host number. This file contains details such as link status, connection speed and discovered devices.
Note
Advanced users only. Modify the driver makefile to enable debugging information. Upon loading, the celerityfc driver displays detailed debugging information which may help troubleshoot the problem.
24
