Attwood 3820, 3800 Series, 3810 warranty Maintenance, Attwood Limited Warranty

Models: 3800 Series 3810 3820

1 2
Download 2 pages 60.51 Kb
Page 2
Image 2

1.Connect one lead to the negative (-) post of the 12-volt supply. Connect the other lead to a fused and switched positive (+) 12-volt supply. Sidelights require 1-amp fusing per lamp: a 1-amp fuse for the Bicolor Combination light, a 2-amp fuse for the Sidelight Pair. Note that navigation rules require sidelights to be operated separately from anchor lights. Use either two switches or a single switch with three positions for off/anchor/running (See Figure 3).

Figure 3

2-Amp Fuse

Switch

2.Check gasket to be sure the hole lip is down. Feed wires and connectors down through the gasket (See Figure 4).

3.Be sure base is seated into the gasket ring all the way around (See Figure 4 Detail).

4.Align base so the hole lip fits down into the wire clearance hole. Insert two #10 stainless steel mounting screws and fasten them to the deck. Note: Do not fasten screws so tightly that the gasket is deformed.

5.To replace lens: Be sure O-ring is seated on the base screw mount. Seat lens so the base tabs fit in the lens grooves and base screw mount lines up with the lens screw hole. Be sure the gasket is outside the lens at the back.

Figure 4

Lens

Lens

Groove

Base Tab

O-Ring

Detail

Base

Gasket

Lens

Gasket

Hole Lip

6.Place stainless steel cover over lens. Be sure gasket is inside the stainless steel cover at the back. Reinstall screw into cover (See Figure 5).

Figure 5

Lens Cover

Gasket

MAINTENANCE

To replace lamp: Remove the cover screw, cover, and lens. You may need to pry the lens from the gasket with a small flat screwdriver, starting in the front of the light.

Remove old lamp by rotating 1/8 turn counterclockwise and pulling forward. Replace lamp with the proper bayonet bulb (Attwood Part Number 912717). Check position of O-ring on the base screw mount. Carefully replace lens and cover on gasket to maintain the waterproof seal. Reinstall cover screw.

ATTWOOD LIMITED WARRANTY

ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331 (“Attwood”) warrants to the original consumer purchaser that Attwood brand products will be free from defects in materials and workmanship under normal use and service for one year from the date of original consumer purchases.

This limited warranty is not applicable if the product has been damaged by accident, improper installation, unreasonable or improper use, lack of proper maintenance, unauthorized repairs or modifications, normal wear and tear, or other causes not arising out of defects in materials or workmanship.

Attwood products are warranted for use on pleasure boats. Any other use— including but not limited to commercial, racing, or non-marine use—are not covered under this warranty. Attwood’s obligation under this warranty is limited to repair of the product at Attwood’s plant or replacement of the products at Attwood’s option without expense to the original consumer purchaser. Any expenses involved in the removal, reinstallation or transportation of the product are not covered by this warranty.

The product must be returned to Attwood’s plant at the address above, postage pre-paid, and insured with proof of original purchase including date. If Attwood is unable to replace the product and repair is not commercially practical or cannot be timely made, or if the original consumer purchaser

is willing to accept a refund in lieu of repair or replacement, Attwood may refund the purchase price, less an amount for depreciation. The acceptance by Attwood of any product returned or any refund provided by Attwood shall not be deemed an admission that the product is defective or in violation of any warranty. Products that are replaced or for which a refund is issued become the property of Attwood.

THIS WARRANTY IS ATTWOOD’S ONLY EXPRESSED WARRANTY OF THESE PRODUCTS. NO IMPLIED WARRANTY INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE EXTENDED BEYOND THE WARRANTY PERIOD STATED ABOVE FOR EACH PRODUCT. ATTWOOD SHALL NOT BE LIABLE FOR ANY DAMAGES, FOR LOSS OF USE OF THIS PRODUCT, NOR FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES, COSTS, OR EXPENSES.

Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations and exclusions may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state.

© 2000

Attwood

Subsidiary Steelcase Inc. 1016 N. Monroe Street, Lowell, MI 49331-0260

Page 2
Image 2
Attwood 3820, 3800 Series, 3810 warranty Maintenance, Attwood Limited Warranty