INSTALLATION, RAISED BASE MOUNT
All-Round Lights
1.Place light in position as shown in Figure 1.
Important: Before drilling, be sure that light will shine within 5° of horizontal when boat is floating.
2.Mark and drill 3/8" (10mm) diameter hole (Figure 4; Sidelight lens is shown).
3.Thread wire leads and base stem into hole. Mark location of screw holes. Proceed to Step 4 below.
Bi-Color Sidelights and Sidelight Pairs
1.Place sidelight(s) in position as shown in Figure 2.
Important: Before drilling, be sure that sidelights will shine straight ahead and within 5° of horizontal when boat is floating.
2.For
3.Thread wire leads and base stem into hole. Align lens division with
4.Remove base and drill 1/8" (3mm) pilot holes for both screws.
5.Bring 12V DC (+) and
6.Activate light to verify proper operation.
7.Apply
8.Align and fasten base with stainless screws. Do not over tighten. (Figure 4)
Figure 4
On
Off
• | Lens Helmet |
• "O" Ring
FINAL WIRING
CAUTION:
Power source must be positive 12V DC only. All positive (+12V DC) wires must be fused to protect the circuit. Attwood Pulsar Navigation Lights require a
1.Neatly thread wires to dash avoiding any areas where abrasion or snagging may occur.
2.Use waterproof crimp on butt joint connectors to attach wires to a switch on the dash that allows for
Figure 5
•
•
Pos. (+)
Neg.
•
12V DC
MAIINTENANCE
For cleaning or to replace bulb, gently twist lens helmet counter
ATTWOOD LIMITED WARRANTY
ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331 (“Attwood”) warrants to the original consumer purchaser that Attwood brand products will be free from defects in materials and workmanship under normal use and service for one year from the date of original consumer purchases. This limited warranty is not applicable if the product has been damaged by accident, improper installation, unreasonable or improper use, lack of proper maintenance, unauthorized repairs or modifications, normal wear and tear, or other causes not arising out of defects in materials or workmanship. Attwood products are warranted for use on pleasure boats. Any other use - including but not limited to commercial, racing, or
Notch
•
•
•
3/8" (10mm) Dia. Hole
must be returned to Attwood’s plant at the address above, postage prepaid, and insured with proof of original purchase including date. If Attwood is unable to replace the product and repair is not commercially practical or cannot be timely made, or if the original consumer purchaser is willing to accept a refund in lieu of repair or replacement, Attwood may refund the purchase price, less an amount for depreciation. The acceptance by Attwood of any product returned or any refund provided by Attwood shall not be deemed an admission that the product is defective or in violation of any warranty. Products that are replaced or for which a refund is issued become the property of Attwood.
THIS WARRANTY IS ATTWOOD’S ONLY EXPRESS WARRANTY OF THIS PRODUCT. NO IMPLIED WARRANTY SHALL EXTEND BEYOND ONE (1) YEAR FROM THE DATE OF ORIGINAL CONSUMER
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations and exclusions may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state.
1/8" (3mm) Pilot Holes
© 2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI
