PB130-024T
Installation Instructions
24-V Low-Voltage Power Base
nApplications
4.1Single SSR with Built-in Transformer
This document describes the connections when the
•RT850
•RT850T
•RC840 electromechanical relay
•RC840T electromechanical relay with
Electrical |
|
|
Panel | Blue | Red |
|
BlackHeater
4.2Multiple SSRs with External Transformer
oSupplied Parts
nOne (1) power base o Two (2) plastic anchors p Two (2) mounting screws
pInstallation Guidelines
For a new installation, choose a location about 1.5 m (5 ft.) above the floor.
Electrical
Panel
| Black | External 24 V |
|
| Transformer |
Heater | Red |
|
|
|
Black
The thermostat must be installed on an inside wall facing the heating system (except for floor heating systems).
Heater
Red
Avoid locations where there are air drafts (top of staircase, air outlet), dead air spots (behind a door), direct sunlight or concealed chimney or stove pipes (except for floor heating systems).
qInstallation Procedure
The installation must be carried out by an electrician and must comply to local electrical codes.
nTurn off power to the heating system at the main electrical panel to avoid electrical shock.
oWire the base according to your application. See typical wiring diagrams in sections 4.1 to 4.4.
4.3Electromechanical Relay with External Transformer
Electrical
Panel
External 24 V
Transformer
Heater
4.4Hot Water Heater Valve
Electrical
Panel
p For a floor heating system installation, con- nect the floor sensor between the S and R ter- minals.
qSecure the base to the wall using the provided screws and wall anchors.
rConfigure the switches located on the control module (if any). Refer to the user guide.
sInstall the control module onto the base. t Apply power to the heating system.
uVerify the installation by checking that the heating system can be turned On or Off using the thermostat.
External 24 V | Valve |
| |
Transformer |
|
rTechnical Specifications
Maximum load: 0.5 A / 24 VAC
Operating temperature: 0°C to 50°C (32°F to 122°F)
Storage:
Size (H • W • D): 75 x 75 x 13 mm (2.9 x 2.9 x 0.5 in)
Wire gauge: 14 to 22 AWG
1/11/06 | 1/1 |