Prior to use of this product, review all safety markings and instructions.
CAUTION | AVIS |
RISK OF ELECTRIC | RISQUE DE CHOC |
SHOCK | ÉLECTRIQUE |
DO NOT OPEN | NE PAS OUVRIR |
|
|
To prevent electric shock, do not remove the cover. There are no
Pour prévenir un choc électrique, ne pas ouvrir le couvercle. Il n’y aucune pièces de rechanges à l’intérieur. Tout ajustement interne doit être fait par une personne qualifié seulement. Référez tout réparation au personnel qualifié.
Warning/Attention:
To prevent fire or shock hazard, do not expose this appliance to rain or moisture. Pour prévenir feu ou choc électrique, ne pas exposé l’appareil à la pluie ou à l’humidité.
WARNING: This apparatus must be grounded.
This product is a safety class 1 product. There must be an uninterruptible safety earth ground from the main power source to the product’s AC input. Whenever it is likely that the protection has been impaired, disconnect the power cord until the ground has been restored.
ATTENTION: Cet appareil doit être mise à la terre. Cet appareil est de classe de sûreté 1. Il doit y avoir un ininterrompable de mise à la terre de sécurité provenant de la source principale de courant de l’appareil de l’entrée du courant alternatif. Quand la protection a été affaiblie, débrancher le fil de courant jusqu’à la mise à terre a bien été réétablie.
The detachable IEC type power input cord supplied is intended for use in regions with mains voltage in the range of
For use in geographical areas with mains voltage outside of the range
AEW-DA550C and AEW-DA660D Installation and Operation
The
For conciseness, only the
The
Front Panel Controls and Functions (Fig. A)
Antennas can be remotely located from the unit. However, due to signal loss in cables at UHF frequencies, use the
Either passive or active antennas may be used. Both antenna input jacks offer switchable +12V DC output on their center pins to operate
Additionally, four jacks on the rear panel provide 12V DC (center positive) to power as many as four receivers operating on 12 volts at up to 500 mA each. Included with the unit are four DC cables appropriate for use with
The
The unit features a steel case with
1.POWER SWITCH: Press switch to apply AC power to unit. Press again to turn unit off.
2.POWER INDICATOR: Shortly after power is applied, the indicator will light.
3.
Figure A Front Panel
ON
POWER
OFF
2 | 3 | 1 | 2 | 3 |