15
Troubleshooting
Symptom | Cause | Remedy | |
| Power cord incorrectly plugged | Make sure the power cord is correctly | |
| plugged into the wall outlet | ||
|
| ||
No led on |
| Check fuses in the fuse panel (after | |
No sound | unplugging the power cord from the wall | ||
| outlet) above the IEC inlet and replace | ||
|
| ||
|
| them with new ones of the same type | |
| Low volume | Turn volume knob right | |
| Faulty or incorrectly plugged signal |
| |
| connectors between Puccini Settanta and | Check cords and their connection | |
| the sources |
| |
Only one in led is on |
|
| |
No sound | Off or incorrectly selected source | Check if the source is on and active and if | |
| it is correctly selected using the in selector | ||
|
| ||
|
|
| |
| Faulty or incorrectly plugged power cords |
| |
| between Puccini Settanta and the | Check cords and their connection | |
| speakers |
| |
Selected in leds are on, volume control |
| Contact your Audio Analogue retailer for | |
works but the leds are off, or selected in | Faulty or incorrectly plugged front panel | connections check and front panel | |
leds are off and volume leds are on |
| substitution | |
|
|
| |
Recording is impossible | Incorrectly selected source | Select the right source using the recording | |
selector | |||
|
| ||
|
|
| |
| No battery/ | Place/replace battery (2 ‘AAA’ batteries) | |
Remote controller doesn’t work |
|
| |
You’re standing too far or on an exceeding |
| ||
| Get closer to the unit or reduce angle | ||
| angle from the front panel | ||
|
| ||
|
|
|
If the suggested remedies should not work or the problem is not shown in the list above, please contact your local Audio