12
Specifications
Parameter | Measurement conditions | Value |
Channels: | - | 2 |
Maximum output voltage: | - | 1.9Vrms |
Frequency response: | - | |
Noise level | Band limits | |
Signal/noise ratio | 98dB | |
Power requirements: | - | 230V |
Power consumption: | - | 40VA |
Specifiche Tecniche |
|
|
Parametro | Condizioni di misura | Valore |
Numero di canali: | - | 2 |
Tensione max di uscita | - | 1,9Vrms |
Risposta in frequenza | - | |
Livello di rumore | Limiti di banda | |
Rapporto segnale/rumore | 98dB | |
Alimentazione: | - | 230V |
Assorbimento: | - | 40VA |
TROUBLESHOOTING
Symptome | Cause | Remedy | |
| Unit is in | Push STBY button on the remote | |
| controller or any button on the front panel | ||
|
| ||
| Power cord incorrectly plugged | Make sure the power cord is correctly | |
Display is off | plugged into the wall outlet | ||
| |||
No sound |
| Check fuses in the fuse panel (after | |
| unplugging the power cord from the wall | ||
| outlet) above the IEC inlet and replace | ||
|
| ||
|
| them with new ones of the same type | |
| Faulty or incorrectly plugged connectors |
| |
Display is on | between Rossini CD Player and the | Check cords and their connection | |
amplifier |
| ||
No sound |
| ||
Incorrectly selected source on the amplifier | Check that Rossini CD Player is correctly | ||
| |||
| selected through the amplifier inputs | ||
|
| ||
CD player is on but the display is off |
| Contact your Audio Analogue retailer for | |
Faulty front panel | connections check and front panel | ||
| |||
|
| substitution | |
| No battery/ | Place/replace battery (2 ‘AAA’ batteries) | |
Remote controller doesn’t work | You’re standing too far or on an exceeding | Get closer to the unit or reduce angle | |
| angle from the front panel | ||
|
| ||
The unit is on but there is no sound | Contact your Audio Analogue retailer for | ||
fuse check and substitution | |||
|
|
If the suggested remedies should not work or the problem is not shown in the list above, please contact your local Audio