I. PREPARATION OF VEHICLE INTERIOR
1.Remove and retain (3) three screws which secure dome light in place. See Figure 1.
2.Disconnect wiring and lay light in a safe place.
FIGURE 1
3.Using O.E. console as a reference, carefully measure and trim headliner as shown. Caution:
Before cutting headliner material, check for wiring or other componentry above headliner. Cut only where indicated. DO NOT OVERCUT
HEADLINER. Make sure that the | 7 1/2" cut is |
centered left to right in vehicle. | See Figure 2. |
4.If speaker upgrade kit was purchased, trim these (*) locations. See Figure 2.
FIGURE 2
5. Construct a jumper harness that will connect the vehicle’s dome light wires to the lights in video system. Connect the white wire from video system to the O.E. pink/blue wire. Connect the black wire from video system to the chassis ground.
See Figure 3.
6. Using a test light, check function of lights.
7. Install O.E. dome light in original manner.
FIGURE 3
3
