12. Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video system housing.

13. Raise video system into approximate position and connect all wiring to components. Connect wiring and cabling to video system per instructions included with video system.

14. Check function of all components and lights. See operating instructions for video system operations check. For further assistance, refer to the video system manual for the technical support phone number listed for your area.

FIGURE 7

15.Insert video system into opening in console. Note: Make sure wires do not get pinched between video system and console. Align holes in housing with clips in mounting bracket. Secure using (4) four 6-32 x 3/4" screws (item 2 pg 2) and (4) four 3.5 mm washers (item 3 pg 2). See Figure 7.

Caution: Do not overtighten screws.

16.Tighten screw previously installed to secure rear of console to headliner. Caution: Do not overtighten screws or damage to vehicle roof may occur.

17.Raise video screen into locked position.

18.Install speaker grille (item 8 pg 2). Align clips in grille with holes in console and press firmly.

See Figure 8.

19.If speaker upgrade kit was not installed, install cover plate (item 9 pg 2) at front of console and secure using (2) two # 6 X 1/2" screws (item 5 pg 2 ).

20.Install cover plate decal (item 10 pg ).

FIGURE 8

5

Page 5
Image 5
Audiovox 50-0311x-015 Series installation instructions