Audiovox ACD-28A manual Setting The Clock/Cd Error Codes, Cd Player Error Codes

SETTING THE CLOCK/CD ERROR CODES

12

SETTING THE CLOCK

1.Switch the vehicle ignition and radio on.

2.Momentarily press the Time/Frequency (T/F) Select button dm so that the time is shown on the display panel.

3.Press and hold the Time/Frequency button until the time display begins flashing. While

the display is still flashing, press the Up Tuning ( ) button to adjust the hours and the

A or P indication, then the Down Tuning ( ) button to adjust the minutes to the correct time.

4.Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and the display will return to the normal indication.

CD PLAYER ERROR CODES

If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.) may appear on the display panel. This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor control of the player. If an error code should appear, try ejecting and re-loading the disc into the player. While the disc is out of the unit, make sure it is clean, undamaged, and loaded correctly (label surface up). You may also try activating the RESET button doon the unit, but this will also erase the time and pre-set memories.

If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.