Dell manual Is 255.255.255.0 , the QuickDeploy IP, Address range is not fully within

Setting	Description
	For example, if the starting IP address is
	192.168.0.250 and the subnet mask is
	255.255.0.0 then the QuickDeploy IP address
	for slot 15 is 192.168.0.265. If the subnet mask
	is 255.255.255.0, the QuickDeploy IP
	address range is not fully within
	QuickDeploy Subnet error message is
	displayed when you click Save QuickDeploy
	Settings or Auto-Populate Using QuickDeploy
	Settings.
iDRAC IPv4 Netmask	Specifies the QuickDeploy subnet mask that is
	assigned to all newly inserted servers.
iDRAC IPv4 Gateway	Specifies the QuickDeploy default gateway that
	is assigned to all the DRAC present in the
	chassis.
Enable iDRAC IPv6	Enables IPv6 addressing for each iDRAC present
	in the chassis that is IPv6 capable.
Enable iDRAC IPv6 Autoconfiguration	Enables the iDRAC to obtain IPv6 settings
	(address and prefix length) from a DHCPv6
	server and also enables stateless address auto
	configuration. By default, this option is enabled.
iDRAC IPv6 Gateway	Specifies the default IPv6 gateway to be assigned
	to the iDRACs. The default value is "::".
iDRAC IPv6 Prefix Length	Specifies the prefix length to be assigned for the
	IPv6 addresses on the iDRAC. The default value
	is 64.

3.Click Save QuickDeploy Settings to save the settings. If you have made changes to the iDRAC network setting, click Apply iDRAC Network Settings to deploy the settings to the iDRAC.

The QuickDeploy feature only executes when it is enabled, and a server is inserted in the chassis. If Set iDRAC Root Password on Server Insertion and QuickDeploy Enabled are enabled, the user is prompted using the LCD interface to allow or not allow the password change. If there are network configuration settings that differ from the current iDRAC settings, the user is prompted to either accept or reject the changes.

NOTE: If there is a LAN or IPMI over LAN difference, the user is prompted to accept the QuickDeploy IP address setting. If the difference is the DHCP setting, the user is prompted to accept the DHCP QuickDeploy setting.

To copy the QuickDeploy settings into the iDRAC Network Settings section, click Auto-Populate Using QuickDeploy Settings. The QuickDeploy network configurations settings are copied into the corresponding fields in the iDRAC Network Configuration Settings table.

NOTE: Changes made to QuickDeploy fields are immediate, but changes made to one or more iDRAC server network configuration settings may require a couple of minutes to propagate from CMC to iDRAC. Clicking Refresh early may display only partially correct data for one or more iDRAC servers.

101