Dell 2 manual DVD Mapping, Enclosure Menu, IP Summary Menu, Settings

DVD Mapping

By using this page, you can view the DVD to server mapping information, map another server to the DVD drive on the chassis, or unmap the existing connection. To give a server access to the DVD, select DVD mapping from the main menu, navigate to the required server, and then press the center Check button.

The DVD drive can be mapped to the server slot only if the DVD is enabled for that server slot. DVD drive can also be unmapped to prevent the use by any of the server slots. The health of the DVD drive will be critical if the SATA cable is not properly connected between the DVD drive and the mainboard. If the health of the DVD drive is critical, the server cannot access the DVD drive.

NOTE: The DVD Mapping feature is displayed on the LCD Main Menu screen only if you have a DVD drive installed.

Enclosure Menu

From this screen, you can navigate to the following screens:

•Front Status

•Rear Status

•Side Status

•Enclosure Status

Use the navigation buttons to highlight the desired item (highlight the Back icon to return to the Main Menu), and then press the center button. The selected screen is displayed.

IP Summary Menu

The IP Summary screen displays the IP information about the CMC (IPv4 and IPv6), and each server that is installed on the chassis.

Use the up and down arrow buttons to scroll through the list. Use the left and right arrow buttons to scroll selected messages that are longer than the screen.

Use the up and down arrow buttons to select the Back icon and press the center button to return to the Enclosure menu.

Settings

The Settings menu displays a menu of items that can be configured:

•LCD Language — Select the language you want to use for LCD screen text and messages.

•Chassis Orientation — Select either Tower Mode or Rack Mode on the basis of installation orientation of the chassis.

•Default LCD Screen — Select the screen (Main Menu, Front Status, Rear Status, Side Status, or Custom) that is displayed when there is no activity on the LCD panel.

•Network Settings — Select to configure the network settings of a CMC. For more information about this feature, see Configuring CMC Network Using LCD Panel Interface.

Use the up and down arrow buttons to highlight an item in the menu, or highlight the Back icon if you want to return to the Main Menu screen.

To activate your selection, press the center button.

219