cmc-active

and <ledState> specifies whether or not the LED should blink. Configuration options:

0 — not blinking (default)

1 — blinking

racadm raid <operation> <component FQDD>, where the operation value is blink or unblink, and the FQDD is for the component's physical disk drive and virtual disk.

Configuring CMC Properties

You can configure CMC properties such as power budgeting, network settings, users, and SNMP and email alerts using the web interface or RACADM commands.

Configuring iDRAC Launch Method Using CMC Web Interface

To configure the iDRAC launch method from the General Chassis Settings page:

1.In the left pane, click Chassis Overview Setup. The General Chassis Settings page is displayed.

2.In the drop-down menu for the iDRAC Launch Method property, select IP Address or DNS.

3.Click Apply.

NOTE: A DNS-based launch is used for any particular iDRAC only if:

The chassis setting is DNS.

CMC has detected that the specific iDRAC is configured with a DNS name.

Configuring iDRAC Launch Method Using RACADM

To update CMC firmware using RACADM, use the cfgRacTuneIdracDNSLaunchEnable subcommand. For more information, see the Chassis Management Controller for PowerEdge VRTX RACADM Command Line Reference Guide available at dell.com/support/manuals.

Configuring Login Lockout Policy Attributes Using CMC Web Interface

NOTE: To perform the following tasks, you must have Chassis Configuration Administrator privilege.

The Log in Security enables you to configure the IP range attributes for CMC login using the CMC web interface. To configure the IP range attributes using CMC web interface:

1.In the left pane, go to Chassis Overview and click Network Network. The Network Configuration page is displayed.

2.In the IPv4 Settings section, click Advanced Settings. Alternatively, to access the Log in Security page, in the left pane, go to Chassis Overview, click Security Log in.

The Log in Security page is displayed.

40

Page 40
Image 40
Dell 2 manual Configuring CMC Properties, Configuring iDRAC Launch Method Using CMC Web Interface, Cmc-active