Table 26. Status Messages Returned by the featurecard -s Command

Status Message

Actions

 

 

No feature card inserted.

Check CMC to verify that the SD card was properly

 

inserted. In a redundant CMC configuration, ensure

 

that the CMC with the SD feature card installed is

 

the active CMC and not the standby CMC.

The feature card inserted is valid and

No action required.

contains the following feature(s)

 

FlexAddress: bound.

 

The feature card inserted is valid and contains the following feature(s) FlexAddress: bound to another chassis, svctag=ABC1234, SD card SN = 1122334455.

Remove the SD card; locate and install the SD card for the current chassis.

The feature card inserted is valid and contains the following feature(s) FlexAddress: not bound.

The feature card can be moved to another chassis or can be reactivated on the current chassis. To reactivate on the current chassis, enter racadm racreset until the CMC module with the feature card installed becomes active.

Use the following RACADM command to display all activated features on the chassis:

racadm feature -s

The command returns the following status message:

Feature Name = FlexAddress

Date/time Activated = 05 Oct 2013 - 11:50:49

Feature installed from SD-card serial number = CN0H871T1374036T00MXA00

Feature Name = FlexAddressPlus

Date/time Activated = 05 Oct 2013 - 11:50:49

Feature installed from SD-card serial number = CN0H871T1374036T00MXA00

Feature Name = ExtendedStorage Current Status = redundant, active Date/time Activated = 05 Oct 2013 - 11:50:58

Feature installed from SD-card serial number = CN0H871T1374036T00MXA00

If there are no active features on the chassis, the command returns a message:

racadm feature -s

No features active on the chassis

Dell Feature Cards may contain more than one feature. After any feature included on a Dell Feature Card has been activated on a chassis, any other features that may be included on that Dell Feature Card cannot be activated on a different chassis. In this case, the racadm feature -scommand displays the following message for the affected features:

ERROR: One or more features on the SD card are active on another chassis

For more information about the feature and featurecard commands, see the Chassis Management Controller for PowerEdge VRTX RACADM Command Line Reference Guide available at the support site.

162

Page 162
Image 162
Dell 2 manual No feature card inserted, Feature card inserted is valid, Racadm feature -s