Mapping a Server to KVM Using CMC Web Interface

Make sure the KVM console is connected to the chassis.

To map a server to a KVM:

1.In the left pane, click Chassis Overview Front Panel Setup .

2.On the Front Panel Configuration page, under the KVM Configuration section, from the KVM Mapped list, select the slot that must be mapped to a KVM, and then click Apply.

NOTE: The KVM allows mapping to all the server slots. Inserting a full–height or replacing a half– height server with full–height server does not change the mapping behavior. However, if the KVM is mapped to a lower slot and the slot has a full–height server, then the KVM is available only through the upper slot. You must remap the KVM to the upper slots.

Mapping the Server to KVM Using LCD

Make sure the KVM console is connected to the chassis.

To map the server to the KVM using the LCD — From the Main Menu screen on the LCD, go to KVM Mapping, select the server that must be mapped, and then press OK.

Mapping a Server to a DVD Drive

To map the server to the chassis DVD drive:

1.In the left pane, click Chassis Overview Front Panel Setup .

2.On the Front Panel Configuration page, under the DVD Drive Configuration section:

From the DVD Mapped drop-down menu, select one of the servers. Select the servers for which chassis DVD drive access is required.

3.Click Apply.

The DVD allows mapping to all the server slots. Inserting a full–height or replacing a half–height server with full–height server does not change the mapping behavior. However, if the DVD is mapped to a lower slot and the slot has a full–height server, then the DVD is available only through the upper slot. You must remap the DVD to the upper slots.

44

Page 44
Image 44
Dell 2 manual Mapping a Server to KVM Using CMC Web Interface, Mapping the Server to KVM Using LCD