SILENT ARMING - ACTIVE
1.Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.
2.Press and hold the Lock button on the keychain transmitter for 2 seconds.
þDash mounted LED begins to flash slowly.
þParking Lights flash one time.
þSiren will not sound.
If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction.
oDoors Lock - Optional
oHeadlight Illumination - Optional
ARMING THE SYSTEM - PASSIVE ( AUTOMATIC )
1.Turn off the engine, exit the vehicle, and close and lock all doors, hood lid and trunk lid.
þDash mounted LED begins to flash rapidly, indicating 30 second passive arming has begun.
2.Opening any protected entry point during the 30 second passive arming cycle will immediately suspend automatic arming and the 30 second passive arming cycle will restart when all doors are closed. At the end of the passive arming cycle;
þDash mounted LED begins to flash slowly.
þParking Lights flash one time.
þSiren sounds one chirp
If the siren did not sound when arming, then the chirps have been turned off, and you should refer to the section titled "ELIMINATING THE ARM / DISARM CHIRPS" in this manual.
oDoors Lock - Optional
Door locking during passive arming is a selectable feature. The alarm can be programmed to allow the doors to lock only when arming using the keychain transmitter and they will not automatically lock during passive arming.
PROTECTION WHILE THE SYSTEM IS ARMED
þOpening any protected door, hood, or trunk lid will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone.
Page 3
128-6802
3 OF 12
