10.Press and release the valet/override switch one time to advance to channel 4 if so equipped. If your system does not have a 4th channel, a long chirp followed by a short chirp tone will indicate that the program mode has been exited.
11.The dash mounted LED will flash 4 times and siren will "chirp" 4 times indicating that the system is ready to accept programming of channel 4.
12.(a)Press and hold any combination of two buttons simultaneously, until the siren emits a long chirp tone. This confirms that programming of channel 4 was successful. Up to 4 transmitters can be programmed, press and hold the selected button of each additional transmitter until the chirp tone is heard.
(b)Press and hold the remaining Opt. button of the transmitter until the siren emits a long chirp tone. This confirms that programming of channel 4 was successful. Up to 4 transmitters can be programmed, press and hold the selected button of each additional transmitter until the chirp tone is heard.
or press and release the push button switch to exit the programming mode,
or turn the ignition switch off to exit the programming mode.
The siren emits a long followed by a short chirp tone indicating that the program mode has been exited.
NOTE: If programming to a Keyless Entry (non alarm) unit, there will be NO chirp indication.
QUICKREFERENCE:
You can program any individual channel, without reprogramming all channels, by following the quick reference chart below. (Not All Units Have 4 Channels)
CHANNEL | VALETSWITCH | LED |
|
|
|
1 | Press and Release 3 Times | 1 Flash |
2 | Press and Release 4 Times | 2 Flashes |
|
|
|
3 | Press and Release 5 Times | 3 Flashes |
|
|
|
4 | Press and Release 6 Times | 4 Flashes |
|
|
|
After the desired channel is programmed, turn the ignition key to the off position to exit programming mode.
4
128-6105
4 of 6
