Audiovox AX-2K4 manual 128-6987 2 of, Programming Transmitters, To Program Additional Transmitters

Models: AX-2K4MS AX-2K4 AX-2K4S AX-2K4MSFL

1 6
Download 6 pages 45.62 Kb
Page 2
Image 2
PROGRAMMING TRANSMITTERS:

Some of the more popular options available for the unused Option Buttons of your transmitter are:

AS 9554 Remote Garage Door Interface AS 9075 Remote car starter

AS 9153 Remote window roll up AS 9256 Remote trunk release relay

Although the most common use of the transmitter buttons are shown on the front page of this guide, any button or button combination can be programmed into any receiver channel. Additionally, if all 4 buttons are used and you require access to a 5th channel, you would program a

combination of buttons to control the 5th function. i.e... You have programmed lock for arm, unlock for disarm, trunk for trunk release, and Opt1 for garage door operation, and you've added a window up module that you want independent control of, you would program un- lock and trunk buttons pressed simultaneously into the receiver to con- trol this function independently. Also, if you do not program a transmit- ter button into channel 2 which is the separate unlock/disarm chan- nel, then whatever button is programmed into channel 1 will serve as both lock/arm & unlock/disarm.

PROGRAMMING TRANSMITTERS:

NOTE: It is important to remember that during the programming mode, each individual step must be completed within 15 seconds of the previous step. If the 15 second time limit expires between steps, the unit will automatically exit the program mode. This is indicated by a long chirp from the siren.

Non alarm models will flash the parking lights only to confirm the transmitter code has been learned and stored.

NOTE: Because the system may be capable of sounding a siren, the vehicle horn, or both, where the siren chirp is referenced be- low, the siren may chirp, the horn may beep, or both devices may sound.

TO PROGRAM ADDITIONAL TRANSMITTERS:

1)Enter the vehicle, and turn the ignition switch to the on position.

2)Press and release the valet push button switch three times.

3)The dash mounted LED will flash 1x, and the siren will chirp 1x, indicating that the system is ready to accept programming of channel #1 which is arm/lock, disarm/unlock/unlock 2, and panic functions.

4)Press and hold the lock or lock/unlock symbol button of the transmit- ter you wish to program for 4 seconds or until a long chirp is heard from the siren.

"Repeat step 4 for each transmitter you wish to program".

NOTE: If your transmitter button has the Lock/Unlock icon on one button, press and release the valet push button switch 2 times then move on to step #8.

5)Press and release the valet push button switch one time to advance to 2

128-6987

2 of 6

Page 2
Image 2
Audiovox AX-2K4MSFL, AX-2K4S manual 128-6987 2 of, Programming Transmitters, To Program Additional Transmitters