OPERA TING INSTRUCTIONS
1 | 4 | 6 | 8 | 5 | 3 |
6. STEREO INDICA TOR (RED)
This will illuminate whenever you have selected a stereo station. If the light flickers or goes on and off as you drive it is an indication that the stereo signal is too weak to reproduce and you should select another station.
| .. |
|
|
| o~ . |
|
|
~ | Irn& | ...~HlOala.,a.O..m |
|
I 8a I 8a laa | ..a 18a LOO. lLJ | ||
| !'rn | [3=5: | - |
| [Ql |
| ,.. |
2 | 10 | 9 | 7 |
1. ON/OFF SWITCHNOLUME CONTROL Rotate this knob to the right to turn the radio on. the desired volume level is obtained.
OM
~
Continue rotation until
7. ANTENNA TRIMMER
It is very important to adjust the ANTENNA TRIMMER for optimum AM
reception. Antenna trimmer is located at the back in the tape slot. Tune in a weak station around 1400KHz and adjust the trimmer with a small
screw driver for maximum output.
8.
This two position switch is incorporated to allow maximum reception in both weak and strong FM signal areas. When tuned to a weak (distant) station push switch in. This will allow maximum signal to the receiver. When in an extremely strong signal area (local), release switch. This will eliminate all weak signals and suppress overly strong signals so as to avoid overloading the receiver input. When moving out of a strong signal
2. TONE CONTROL
Allows you to emphasize bass or treble tones to suit your listening
preference. Rotate clockwise to increase treble, counterclockwise to increase bass.
3. LEFT/RIGHT BALANCE CONTROL
Allows you to adjust stereo balance between left and right speakers.
Rotate clockwise to emphasize right speaker. counterclockwise to em- phasize left speaker.
4. AM/FM SELECTOR
T o change from AM to FM band depress this button. In the
will receive FM and FM Stereo broadcasts. In the outward position (depress and release) you will receive AM broadcast.
5. MANUAL TUNING
By rotating the knob you can manually change the station. When using this control to select a station always adjust it so you are receiving the full signal (exactly in the center of the broadcast frequency).
area, return switch to the "distant" position.
Note: The
9. CASSETTE SlOT
Hold the cassette with the expos~d tape edge to the right and insert into the cassette slot. Depress fully until the cassette is engaged. It will start
playing immediately.
Note: Check that the tape is tightly wound on the spools before inserting.
10. FAST-FORWARD/EJECT BUTTON
This button performs two functions. Tb eject a cassette simply depress this button fully then release. The cassette will eject for easy removal. This button also allows you to rapidly advance the tape so you can skip any undesired tape programs. To use