Audiovox FRS122-2 manual Operating Modes and Features, Channel Selection

Operating Modes and Features

FRS Operation:

-Press and hold the Power On/Off button for 2 seconds to turn on power.

-Press the MODE button so the Channel number flashes.

-Select the desired channel with the Up (10) and Down (11) Buttons.

When receiving a call, the icon appears to indicate an incoming call.

-Press and hold the PTT button (4) to transmit, then speak into the

microphone clearly and slowly. The Transmit icon ( ) appears on the display while the button is pressed.

-Release PTT Button (4) to receive.

-Communication can only be accomplished when the channel and CTCSS tone frequency of at least two parties are the same.

-The CTCSS subcode (01-38) will be displayed on the LCD panel if the CTCSS tone frequency function is enabled (not oF).

Channel Selection

In order to communicate with other FRS units, both the transmit- ting and receiving party must be on the same frequency.

The FRS122-2 has 14 channels (frequencies) indicated by the large digits on the LCD display panel. Channels 1 through 14 are the shared FRS channels.

Communication with Audiovox FRS

and compatible units is possible on these 14 channels. Before trans- mitting on the selected channel, press the Monitor (M) Button (2) to check the activity on that channel. If there is activity on the selected channel, change to another channel that is clear.

11

128-6675

11 of 24