..
5. Pre-wire radio. Slide radio into din sleeve until itlocks into place. Note: Use either rear bushingor perforated strap to secure rear of radio.RADIO REMOVAL (IF NECESSARY)
1. Unsnap trimring on face of radio.
2. Insert removal tool in slotted holes on sides of
radio until bottomed. Spread tools outward slightly
and pull radio toward you. Remove tools and
slide radio fully out.
DIN MOUNTING (EXAMPLE:VOLKSWAGON)
SEE FIG. 1
1. Verify opening is within following dimensions:
A. Height 52mm- 53mm (23/64" -23/32")
B. Width 182mm -184mm (75/32" -71/4")
2. If opening is less, carefull file to exact size
required (DO NOT OVER FILE).
3. Remove din sleeve from radio and place into
opening.
4. Bend tabs outward to lock sleeve into dash.
rFjG:1l .~ ~ --USE EITHER BUSHING
I rlu. I I 11;r'.../ OR PERFORATED STRAP
@ TO SUPPORT REAR OF RADIO
.1 \LJ
\\~
4
) ~
BEND TABS
~
~
~@~ I;/
~ ~' (J(~
~~ ~II ~lY A (;AO7
r
OUTWARD
..".J
",~
~
0
DASH PANEL
.;J-
DIN SLEEVE .~
-~~ l ~~
~~ ~
~
,
~ADIO REMOV ~ """' ~/ ~( ~
/I,f '"""
:.,.( APPLY SLIGHT TRIMBEZEL (INSTALLED ON RADIO)
1..., j ~
REMOVAL TOOL TRIMRING
~
QUICKIE BOL T
/'