This button is used to release the mechanism that holds the front panel to the chassis. To detach the front panel, press the button so that the left side of the panel is released. Grasp the released
-6-
FRONT PANEL RELEASE BUTTON
RE-SET BUTTON

in a random shuffled order (SHF will appear on the display panel). In Shuffle Play mode, the Forward Track Select (+) will also select tracks in the random order instead of the normal progression. Backward Track Select (–)will only go back to the beginning of the track in play. The Shuffle Play mode can be canceled by pressing the button again (SHF indication will disappear from the display panel) or by activating the Repeat Play cp or Track Scan cr functions.

cr TRACK SCAN ( )

During disc play, press this button to play the first 10 seconds of each track on the disc (SCAN will appear and the track number on the display panel will flash during Track Scan operation). When a desired track is reached, press the Scan button again to cancel the function (SCAN will disappear and track number will stop flashing) and play of the selected track will continue. Track Scan mode will also be canceled by activating the Repeat Play cp, Shuffle Play cq, Track Select cm or Cue/Review cn functions.

cs DISC EJECT ( )

Disc play is stopped, the disc is ejected (EJ on display panel), and the unit will change to radio operation by pressing this button. If the disc is not removed from the unit within 10 seconds of being ejected, it will automatically be re-loaded into the unit to prevent damage ( IN will appear on the display panel). Press- ing the Eject button again before removing the disc will also re- load the disc into the unit. Discs may be loaded or ejected with

the ignition switch on or off.

ct

side and pull it off of the chassis. To re-attach the panel, position the right side of the panel in place first and then press the left side of the panel until the mechanism locks it into place.

NOTES ON USE OF FRONT PANEL

1. Make sure the front panel is right-side-up when attaching it to the chassis as it cannot be attached when up-side down.

2. Do not press very hard on the front panel when attaching it to the chassis. No more than light to moderate pressure should be needed.

3. When attaching the front panel, make sure the right side is correctly engaged before pressing the left side to lock it into position.

4. When taking the front panel with you, please use the supplied carrying case to protect the panel from dirt and damage. Make sure there is no dust or dirt on the electrical terminals on the back of the panel as this could cause intermittent operation

cu or other malfunctions.

A Re-Set button is located on the front of the chassis (front panel must be removed to access the button). The re-set circuitry is provided to protect the microprocessor circuitry and should only be activated under the following circumstances as it will erase the time and pre-set memories.

1.Upon initial installation after all wiring is complete.

2.After the position of the frequency step switch on the bottom of the chassis has been changed.

3.If there is a malfunction of any of the switches on the unit, pressing the Re-Set button may clear the system and return to normal operation.

Page 7
Image 7
Audiovox P-98 manual Cr Track Scan, Cs Disc Eject