Audiovox P945W Cr LOCAL/DISTANT LOC Selector, CsMODE Selector Mode, Dl Front Panel Release Button

cr LOCAL/DISTANT (LOC) SELECTOR

This feature is used to select the strength of the signals at which the radio will stop during Automatic Seek Tuning. Press- ing and holding this button will select the Local setting (LO- CAL will appear on the display panel) and only strong (local) stations will be received. Pressing the button again will select the normal Distant setting (Dx will appear on the display panel). The radio will stop at a wider range of signals, including weaker (more distant) stations.

csMODE SELECTOR (MODE)

This button is used to select the radio, or the playback mode for the CD player or remote CD changer (if installed). Each press of the button will select a different mode as indicated on the display panel.

During CD player operation, this button may be used to change to radio or remote CD changer mode ("CDC AUX") without ejecting the disc (the CDP indication will remain on the display panel to show that a disc is still loaded in the unit). Press the button again to return to integral CD player mode and resume play of the disc from the point at which it was stopped.

ct & cu DISC SELECT (D.UP & D.DN)

These buttons are used to increase or decrease selection of a desired disc for play in the remote CD changer. To advance to a higher number disc, press the D.UP button ct. To return to a lower number disc, press the D.DN button cu. The number of the disc in play will be shown on the display panel.

dl FRONT PANEL RELEASE BUTTON

This button is used to release the mechanism that holds the front panel to the chassis. To detach the front panel, press the button so that the left side of the panel is released. Grasp the released side and pull it off of the chassis.

To re-attach the panel, position the right side of the panel in place first and then press the left side of the panel in until the mechanism locks it into place.

dm THEFT-DETERRENT LED

The theft-deterrent Light Emitting Diode (LED) is located behind the front panel and is accessible when the front panel is removed. The flashing light serves as a visual warning to the would-be thief that the unit has been disabled by removal of the front panel.

dn RESET BUTTON

A RESET button is located on the front of the chassis (front panel must be removed to access the button). The RESET circuitry is provided to protect the microprocessor circuitry and should only be activated under the following circumstances as it will erase the time and pre-set memories:

1.Upon initial installation after all wiring is completed.

2.After the position of the frequency step switch on the bottom of the chassis has been changed.

3.If there is a malfunction of any of the switches on the unit, pressing the RESET button may clear the system and return to normal operation.

-8-