Audiovox P953ESP 128-6880 8 of, Notes On Use Of Front Panel, do FRONT PANEL RELEASE BUTTON OPEN

dl PRE-SET SCAN (PS) /AUTO-STORE TUNING (AS)		do FRONT PANEL RELEASE BUTTON (OPEN)
Press this button momentarily to scan the stations pre-set into the
AM band, or the six memories of each FM band. The unit will stop		This button is used to release the mechanism that holds the front
		panel to the chassis. To detach the front panel, press the button so
at each pre-set station for 5 seconds before continuing to the next
		that the panel drops to the lowered position. Grasp the panel at the
pre-set station (the pre-set number on the display panel will flash
		middle and pull it off of the chassis. To re-attach the panel, press it
during Pre-Set Scan operation). Press the button again momentarily
		straight onto the chassis until the mechanism locks it into place.
to stop Pre-Set Scan operation and remain on the selected
frequency.		dp REMOTE SENSOR
Pressing and holding the button for longer than 2 seconds will
activate the Auto-Store Tuning feature which will automatically scan
and enter up to 6 stations into the pre-set memories of each FM		The sensor to detect the infrared signal from the wireless remote
		control is located behind the VFD display lens. For optimum
band and the AM band. If you have already set the pre-set memories
		operation of the remote control, always aim the control at the VFD
to your favorite stations, activating the Auto-Store Tuning feature
		display.
will erase those stations and enter the new ones. This feature is
most useful when traveling in a new area where you are not familiar
with the local stations.		NOTES ON USE OF FRONT PANEL
dm THEFT-DETERRENT LED
		1. Make sure the front panel is positioned correctly when slid-
Located on the chassis behind the front panel, a light-emitting diode		ing it into the front mounting plate, as it cannot be attached
(LED) will flash when the panel is physically removed. The flashing		when up-side down. Use moderate pressure to fully seat
light serves as a visual warning to the would-be thief that the unit has
		the panel into position.
been disabled by removal of the front panel.
		2. To verify correct panel installation, swing the panel as -
dn RESET BUTTON
		sembly up into position until it locks easily into place. If
The RESET button is located to the right of the theft deterrent LED.		any resistance is encountered, re-check panel orienta -
The reset circuitry should only be activated under the following		tion in chassis mounting plate.
circumstances as it will erase the time and pre-set memories:		3. When taking the front panel with you, please use the sup -
1.	Upon initial installation after all wiring is completed.	plied carrying case to protect the panel from dirt and
2.	If there is a malfunction of any of the switches on the unit,	damage. Make sure there is no dust or dirt on the
		electrical terminals on the back of the panel as this could
	pressing the RESET button may clear the system and return

to normal operation.	cause intermittent operation or other malfunctions.
	-8-

128-6880

8 of 20