WIRING INSTRUCTIONS
to an "Accessory" or "Radio" terminal in the car's fuse block. This will turn the amplifier on and off with the ignition key, regardless of whether the car stereo is on or off. The remote
4.Speaker Connections
Only 4 Ohm or 2 Ohm impedance speaker(s) can be used with the amplifier. Wire it to the speaker terminals as per the appropriate wiring diagram. For most applications, #18 gauge wire should be used for the speaker leads but in no case thinner than #20 gauge. For leads in excess of 10 feet, #16 gauge is recommended. When wiring the speaker, pay careful attention to the polarity of the terminals on the speaker and make certain they correspond to the polarity of the corresponding terminals on the amplifier. DO NOT ground either of the speaker leads to the chassis of the vehicle.
5.Input Connections
This amplifier features
both ends to connect the stereo to the amplifier and keep the cable lengths to a minimum to avoid noise.
If the car stereo does not provide
6. Remote Sub-Woofer Level Control Connection
Remote