Audiovox PAB-1500D manual Installation Instructions, Installation Diagram, You Drill

INSTALLATION INSTRUCTIONS

1.Select a mounting area where the amplifier will have sufficient air circulation for proper cooling. Inadequate air circulation will cause the temperature of the amplifier to rise and will trigger the thermal protection mode.

2.Place the amplifier on the mounting surface and mark the locations of the four mounting holes as shown in the illustration at the right.

3.Remove the amplifier and drill a 1/8" hole at each of the four locations.

CAUTION: Before drilling the holes, look at the underside of the mounting surface. Always check carefully to avoid drilling into wiring, braces, fuel or brake lines. CHECK BEFORE

YOU DRILL !

4.Apply a self-adhesive rubber washer to the bottom of the amplifier at each of the 4 screw locations. Secure the amplifier to the mounting surface using the self-tapping screws provided.

5.Attach the plastic end panels to the amplifier by pressing them into position on the amplifier.

INSTALLATION DIAGRAM

END PANELS

SELF-TAPPING SCREW

BASS	BOOST
OFF
	18dB/60Hz
12dB/45Hz

1/8" DIA.

HOLE

RUBBER WASHERS

MOUNTING SURFACE

-3-