Brother DH4-B980 instruction manual Installing the motor, Installing the machine head

3. INSTALLATION

3-2. Installing the motor

(1)

(3)
(4)	(2)

1098Q

1.Insert the three bolts (1) into the work table.

2.Turn the work table upside down to make it easier to install the motor (2).

3.Align the motor (2) with the bolts (1), and then install the motor (2) to the underside of the work table with

the three washers (3) and the three nuts (4).

Note: Do not use the cushion rubber. If you use it, V belt tension cannot be adjusted.

3-3. Installing the machine head

	(8)
	(3)
	(4)
	(5)
(3)
(4)
(5)
(2)	(1)
(1)
(9)
	(6)
	(7)
(6)
(7)
1099Q	0808Q

1.Insert the accessory bed stand cushions A (1) into the bed stand, and then place the machine head on top of the work table.

Note: When placing the machine head on top of the work table, have two or more people there to hold the handles A and B and the rear of the head C.

2.Open the front cover (2), and then use the bed stand mounting bolt (3), washer (4), cushioning rubber (5), bed stand cushion A (1), large washer (6) and nut (7) to attach the front right corner of the bed stand to the work table.

3.Open the rear cover (8), and then attach the bed stand to the work table in two places inside the stand in the same way as in step 2. above.

4.Remove the fixing bolt (9) and the washer.

Note: The fixing bolt (9) and washer should be kept, as they will be needed again if the machine head is moved.

5.Raise the machine head, and then attach the front left corner of the bed stand to the work table in the same way as in the steps above.

Note: Make sure that steps 2. to 4. above have been completed before raising the machine head.

4

RH-9800