Brother DH4-B980 Selecting a program number, Changing the mode, Changing the cutting timing

6. USING THE OPERATION PANEL AND FRONT PANEL

If the power is turned on and the RESET switch is then pressed, the feed bracket will move to the cloth setting position. Operations such as selecting a program number, changing the operation mode and selecting the cutting method can then be carried out.

6-2. Selecting a program number

A maximum of nine different eyelet shapes can be programmed.

	1. Press the PROGRAM NUMBER button (1). (Check
	which of the mode indicator illuminates.)
		In automatic, feed or manual mode, the program
		numbers are displayed in the program number
(2)		display window (2) in the following order each time
		the button is pressed.
	→	1→	2			9
	Note: If			cycle programs have been input, the
			sequence will be as follows:
			→	1 →	2				9→ → → →
(1)			(	indicates a cycle program.)
	*	In programming mode, the program numbers are
		displayed in the program number display window
		(2) in the following order each time the button is
1128Q		pressed.
		→	1 →	2			9 →	C

6-3. Changing the mode

(1)

1019Q

1.Press the MODE button (1).

*The mode changes in the following order each time the button is pressed.

→ AUTO → FEED → MANUAL → PROGRAM

Automatic mode is used for normal sewing.

Feed mode is used to move the feed bracket with out sewing in order to check component positions.

Use the Manual mode to check the machine operation when sewing by turning the upper shaft pulley by hand.

Programming mode is used when setting programs.

6-4. Changing the cutting timing

(1)

When "BEFORE" (cutting before sewing) is selected, the knife operates before the buttonhole is sewn.

When "OFF" (no cutting) is selected, the knife does not operate.

When "AFTER" (cutting after sewing) is selected, the knife operates after the buttonhole is sewn.

1.Press the KNIFE button (1).

*The cutting timing changes in the following order each time the button is pressed.

→ BEFORE → OFF → AFTER

1129Q

20

RH-9800