Brother DH4-B980 instruction manual Threading the gimp, Setting the material, Correct Use

5. CORRECT USE

5-7. Threading the gimp

Remove the cloth presser plates (refer to page 13), and then thread the gimp as shown in the illustration below. Once threading is complete, replace the cloth presser plates.

<-00, -01> 0885Q

0884Q

<-02>

(1)

Pass the gimp through the hole of the thread tension stud (1).

Refer to “9-17. Adjusting the gimp length after trimming (-02)” (Page 54).

0886Q

5-8. Setting the material

(1)	(1)
	(1)
(2)
	(2)

10 - 30 mm

(2)(2)

0889Q 0890Q

1.Insert the material so that it touches the right and left cloth guides (1).

2.The sewing margin can be adjusted to within 10 - 30 mm.

3.Loosen the screws (2) at left and right and move the cloth guides (1) back and forth to adjust the sewing margin.

18

RH-9800